Automatic gates and garage doors make life easier — until they stop working because of poor wiring, surges, or water damage. We install and repair safe electrical connections for gate and garage motors across Victoria Falls, keeping them reliable through storms and load-shedding.
Our installations use the correct cable size, isolators, and surge protection. We wire directly from your DB board or nearest supply point, ensuring clean power that doesn’t interfere with the rest of your system. Every circuit is tested, labelled, and neatly finished.
If your gate motor keeps tripping, stopping halfway, or won’t respond after a storm, we test supply voltage, earthing, and control wiring. Often it’s a loose neutral, corrosion in the junction box, or a faulty isolator — we fix what’s needed without replacing everything.
We also integrate motors safely with inverters and generators. Proper separation and changeover wiring prevent back-feeds or overloads so your motor runs smoothly even when the grid is off.
From small homes in Chinotimba and Mkhosana to lodges and shops in CBD or Aerodrome, we keep access systems running safely, cleanly, and ready for daily use.
FAQs
Do you install new power feeds for gate and garage motors?
Yes. We run dedicated circuits with correct cable sizes, waterproof conduits, and isolators close to the motor. This stops nuisance tripping and voltage drop over long runs.
Why does my gate motor trip the breaker or blow fuses?
Usually moisture, undersized wiring, or a shared neutral. We test for earth leakage, check voltage, and correct wiring or replace damaged components.
Can you connect my gate motor to an inverter or solar system?
Yes — safely. We check motor wattage and configure wiring so it doesn’t overload your inverter or drain batteries too quickly.
How do you protect motors from lightning and surges?
We install surge protection at both the DB and motor point, and make sure the motor’s casing is properly earthed. In Victoria Falls, that’s key during storm season.
Do you replace burnt or faulty isolators and plugs?
We do. We replace damaged isolators, corroded connectors, and loose joints, restoring clean and safe operation for any motor brand.
Do you handle both sliding and swing gates?
Yes. We wire and maintain all gate and garage motor types — single, double, sliding, or roller door systems.