Automatic gates and garage doors are convenient only when the power feed is safe and reliable. We install, rewire, and repair electrical connections for gate and garage motors across Mutare.
From driveway motors in Fairbridge Park and Greenside to roller doors in the CBD, we provide proper isolators, weather-rated power points, and neat conduit routing that lasts.
If your motor trips the breaker, shocks when touched, or stops after rain, the cause is usually earthing problems, water ingress, or weak cabling. We diagnose the fault, rewire correctly, and add surge protection so control boards survive grid return spikes.
New build going up? We coordinate with your builder or installer so sleeves and cables land in the right spot before plastering or paving, avoiding messy surface conduits later.
For complexes and small businesses in Chikanga, Dangamvura, Murambi, and Nyakamete, we handle multiple motors, tidy DB terminations, and clear labelling so future maintenance is simple.
Expect practical advice on backup options too — small batteries or limited inverter supply where capacity allows, without risking nuisance trips.
We work cleanly and quickly, keeping cables protected from weather and garden work. You’ll get sensible placement of isolators, sealed junctions, and a safe, documented finish ready for everyday use.
FAQs
1) Can I plug my gate motor into an extension cord?
Not recommended. Motors need a fixed, weather-rated supply with an isolator and surge protection. Extensions cause voltage drop, moisture issues, and safety risks.
2) My gate motor died after a surge — can you help?
Yes. We test supply voltage, board fuses, and cabling, then add surge protection and correct earthing to reduce repeat failures when ZETDC power returns.
3) Do you install new power points for outdoor motors?
Yes. We run a dedicated circuit from the DB or nearest distribution point, fit an external isolator, and route conduit to keep cables protected from sun and rain.
4) Can I keep my gate or garage working during outages?
Where capacity allows, we can connect a small backup battery or limited inverter supply. We’ll advise what’s realistic so the rest of your system stays stable.
5) The motor trips the breaker when it starts — why?
Common causes are undersized cable, wrong breaker curve, tight gate travel, or water in the motor housing. We fix the wiring issues and recommend mechanical servicing if needed.
6) Can you handle multiple entrances at one property?
Absolutely. We connect and label each motor clearly at the DB and provide a simple diagram — useful for complexes, workshops, and small malls.