Automatic gates and garage doors make life easier — until the power feed fails or the wiring shorts out. We install and repair gate and garage motor connections across Masvingo, keeping systems running safely through load-shedding and surges.
Our work covers both new installations and rewiring of existing motors. We use the right cable size, proper conduit, isolators, and protection devices so motors don’t burn out or trip your DB unnecessarily. Every connection is tested, labelled, and surge-protected.
If your gate stops midway or the garage door won’t respond, we test voltage, cabling, and safety sensors to find the cause — not just the symptom. Often it’s a loose neutral, corroded junction, or faulty supply from the DB.
We also integrate motors with inverters or solar systems safely, ensuring they only run when enough backup power is available. No risky cross-wiring or overloads — just a clean, dependable connection that lasts.
We work daily in CBD, Rhodene, Target Kopje, Mucheke, Hillside, Zimre Park, Runyararo, and Eastvale. Expect tidy installations, safe operation, and clear guidance on use and maintenance.
FAQs
Do you install new electrical feeds for gate and garage motors?
Yes. We run dedicated circuits from your DB to the motor point with proper conduit, isolation, and earthing. This prevents voltage drop and tripping caused by shared circuits.
Why does my gate motor keep tripping the breaker?
Usually from poor wiring, water ingress, or incorrect cable size. We test for earth leakage and inspect joints or connections that may have corroded or overheated.
Can you connect my gate motor to an inverter or solar system?
Yes — safely. We calculate the motor’s load and setup so it doesn’t drain batteries unnecessarily. We also isolate it from other circuits to prevent back-feeding.
Do you replace burnt or damaged motors?
We handle the electrical side — power feeds, isolators, breakers, and surge protection. If the motor itself is burnt out, we can work with your installer or technician to reconnect safely after replacement.
How do you protect motors from power surges?
We install surge protection at the DB and often add an inline protector at the motor point. Combined with proper earthing, this reduces damage from spikes when ZETDC restores power.
Do you fix both sliding and swing gates?
Yes. We handle all types of gate motors and garage door systems, ensuring safe wiring and correct operation regardless of brand.